Impeller Flow Sensor Series 4000

  • Large Pipe diameters
    up to 48“ special version up to 120”
  • High Accuracy
    Better than 1%
  • Large temperature range
    PVC – 60°C  // PVDF – 104°C
Request A Quote

The series 4000 is available in ½”, ¾” and 1” pipe sizes and is molded of PVC or PVDF materials. The compact design allows the series 4000 to replace old style magnetic sensors with little or no piping changes.

The proprietary non-magnetic detection circuit is available with two outputs: A low impedance 3-wire 5 Volt DC square wave signal (that can be pulled up to 20 Volts) capable of travelling up to 600 m without amplification or a 2-wire loop powered 4–20 mA current analog signal. These two signal formats are compatible with most data acquisition or PLC equipment.

Digital displays, scalers, transmitters and control relays for use with series 4000 are also manufactured.

PVDF versions are compatible with all PVDF piping systems including SYGEF, KYNAR, SUPER PROLINE and SANITECH. Adapters are available for use with other plastic or metallic piping systems.

General Specification
Nominal pipe size ½“, ¾“, 1“ (20, 25, 32 mm)
End connections

PVC – plain end pipe

PVDF – socket weld/union

Max. pressure rating

PVC – 350 psi@73°F (23°C)

PVDF – 275 psi@65°F (18°C)

Max. temperature rating

PVC – 140°F (60°C)

PVDF – 220°F (104°C)

Flow range

0,3 – 6 m/s

Low flow range 0,07 – 2,4 m/s
Accuracy
Better than 1%
Repeatability
± 0.5%
Power

Digital output: Supply voltage 9 – 29 VDC, Supply current 2 mA maximum

Analog output: 10 VDC minimum to 35 VDC maximum. The combination of loop power supply voltage and loop series resistance must insure that the device voltage remains within these limits over the 4-20 mA output span.

Signal
 
Digital output: 5 Volt CMOS and LSTTL compatible
Analog output: 4-20 mA analog output with offset compensation for ripple less than 0.25% of full scale
 
Cable

Digital output – 3 wire

Analog output – 2 wire

 
 
 

- Pure water application
- Industrial application