Impeller Insert Flow Sensors Model 220BR & 220SS

  • Medium
    Water, Pharmaceutical media
  • Flow Range 
    from 12 to 300000 l/min
  • Temperature 
    from 0 to 100 °C
  • Pressure
    from 0 to 27 bar
Request A Quote

The series Impeller 200 flow sensor is an insertion style flow sensor constructed of metallic and non-metallic materials. These sensors are designed for service in corrosive and non-corrosive liquids.
The series can be installed in pipe sizes of 3” up to 40” (special models up to 120”) and includes a special potted version (IR models) for irrigation applications (enabling direct mounting in the earth).

The series 200 flow sensors feature a six bladed impeller design with a proprietary non-magnetic sensing mechanism. The forward swept impeller shape provides higher, more consistent torque and is less prone to be fouled by water borne debris. The forward curved shape coupled with the absence of magnetic drag provides improved operation and repeatability even at lower flow rates. This is especially true where the impeller is exposed to metallic or rust particles found in steel or iron pipes. As the liquid flow turns the impeller, a low impedance square wave signal is transmitted with a frequency proportional to the flow rate. The signal can travel up to 600 m between the flow sensor and the display unit without the need for amplification. All sensors except irrigation versions are supplied with 6 m of Belden type 9320 two conductor shielded cable.

General Specification
Temperature ratings

Standard version: 105°C (221°F) continuous service

Irrigation version: 66°C (150°F) continuous service

PVC version: 60°C (140°F) continuous service

Pressure ratings for 220BR

- At 24°C  27 bar

- At 135°C  22 bar

Pressure ratings for 220SS

- At 24°C  27 bar

- At 135°C  22 bar

Pipe size range 3” up to 40”
Recommended design flow range

0,15 to 9 m/s

Initial detection below 0,1 m/s

Accuracy
±1.0% of full scale over recommended design flow range
±4.0% of reading within calibration range
Repeatability
±0.3% of full scale over recommended design flow range
Linearity
±0.2% of full scale over recommended design flow range
Output frequency 3.2 Hz to 200 Hz
Output pulse width
 
5 msec ±25%
 
Electrical cable for standard sensor electronics 70 cm of 2-conductor 20 AWG shielded U.L type PTLC wire provided for connection to display or analog transmitter unit.Rated to 105°C. May be extended to a maximum of 600 m with similar cable and insulation appropriate for application
 
 
 
Electrical cable for IR sensor electronics 1,2 m of U.L. style 116666 copper solid AWG 18 wire with direct burial insulation Rated to 105°C.
Sensor sleeve and hex adapter for 220BR Sleeve: Admiralty brass, UNS C44300; hex adapter: valve bronze, UNS C83600
Sensor sleeve and hex adapter for 220SS 316 series stainless steel

- Industrial energy consumption metering with energy meters.

- chemical injections for water treatment